Pure Direct and Pure Audio modes are part of the multi-channel mode and utilize the high quality multi-channel DAC. USB Audio goes through a separate high performance stereo DAC board. Pure Audio is a 2-channel Stereo mode where multi-channel inputs from the source are converted to 2 channel audio. Pure Direct is a pass-through (from the […]
Playback from hard disk or DLNA (LAN) can only support up to 1080P resolution. Playback from HDMI support HDMI 1.4 4K but not HDMI 2.0 4K. The HDMI 1.4 specification supports 4K formats: 3840 pixels wide by 2160 pixels high @ 24Hz | 25Hz | 30Hz 4096 pixels wide by 2160 pixels high @ 24Hz
These are manufacturer preset values that have no meaning to end users. It was part of development setup that should have been removed. This setup will be removed in future firmware update. Please ignore them.
These are all marketing descriptions.nnBass management is the LFE in the audio setting (OSD setting > Setup > Speaker Setup > LFE Level)nn”Increasing the performance of single/double post positioning devices” and “comprehensive cross-over design” means there are variety of settings you could configure the unit to suit your system, such as speaker range/position, speaker size, […]
Sub output is available for all selections.
#define REMCODE_OFF 0x02 #define REMCODE_ON 0x20 #define REMCODE_DIRECT 0x0e #define REMCODE_STEREO 0x13 #define REMCODE_MODEDN 0x11 #define REMCODE_MODEUP 0x19 #define REMCODE_INPUT1 0x1f #define REMCODE_INPUT2 0x03 #define REMCODE_INPUT3 0x04 #define REMCODE_INPUT4 0x05 #define REMCODE_INPUT5 0x1c #define REMCODE_INPUT6 0x06 #define REMCODE_INPUT7 0x07 #define REMCODE_INPUT8 0x08 #define REMCODE_Bluetooth 0x09 #define REMCODE_AMFM 0x0a #define REMCODE_HD5 0xFE #define REMCODE_HD6 0xFD #define […]
Go to OSD setup. Select Setup tab, then Input Config and then Input setup. Go to Tuner setup. Choose your desire frequency station you wish to store as preset. Once the frequency is selected, go to Memory option: “Choose your desired station. 50 preset stations”
Please download the latest firmware for HD-AVP and HD-AVA.
DAC’s Volume Control Basic A DAC typically has a mix of analog and digital inputs. Some DACs convert the analog input into digital to utilize the DAC’s internal digital volume control and inputs selection, avoiding expensive analog preamp and volume control as described above. The performance degradation of the analog input that has to go […]
USB Host & USB Client USB Audio is a standard for digital audio used in PCs, smart phones and tablets to interface with audio peripherals. The source device that produces the data is called the USB Host and the receiving end is the USB Client. So, if a smartphone is connected to a computer, the […]
